Roborock Saros 10 Robot Vacuum with Refill & Drainage System

This is the plumbed configuration of Roborock's flagship-class Saros 10: the same 22,000 Pa HyperForce® robot, paired with a RockDock® Ultra that connects directly to your home's water supply and drain. The dock refills its clean water automatically and sends dirty mop water down the drain, so you never carry tanks to a sink - Roborock quotes up to 7 weeks of hands-free operation across dust emptying, warm water tank refilling, 176 F hot water self-cleaning, and automatic detergent dispensing.

The robot itself is the slimmest in Roborock's flagship line: the RetractSense™ Navigation System lowers the LDS turret into the body for a 3.14-inch (7.98 cm) profile that fits under low sofas and beds. ReactiveAI 3.0 obstacle recognition combines front triple structured light, an RGB camera, and VertiBeam™ lateral structured light, while the VibraRise® 4.0 mopping system scrubs with dual sonic vibration zones at up to 8N of pressure. The DuoDivide™ main brush and FlexiArm™ Riser side brush keep hair from tangling either brush.

Choose this version if your laundry room, kitchen, or bathroom has a water line and drain within reach of the dock. If you would rather skip plumbing entirely, the same robot is sold as the Saros 10 with Dual Anti-tangle System, whose RockDock® Ultra 2.0 uses onboard tanks.

• Refill & Drainage System: The dock ties into your water supply and drain, refilling clean water and flushing dirty water automatically - no tanks to carry, and up to 7 weeks of hands-free operation including dust emptying and detergent dispensing.
• 22,000 Pa HyperForce Suction: Flagship-class suction digs embedded debris out of carpet and clears hard-floor grit in a single pass, backed by a 6,400 mAh battery with 2.5-hour fast charging.
• RetractSense Navigation: The LDS turret lowers into the chassis for a 3.14-inch (7.98 cm) profile, so the robot cleans under sofas, beds, and cabinets, then raises the sensor again for full-range mapping.
• Dual Anti-tangle Brushes: The DuoDivide™ main brush channels hair to the suction inlet and the FlexiArm™ Riser side brush resists wrap - rated 0 percent tangle rate and 100 percent hair removal on carpet.
• VibraRise 4.0 Mopping: Dual sonic vibration zones scrub at 4,000 cycles per minute with up to 8N of pressure and heated water up to 158 F; the mop detaches automatically in vacuum-only modes.
• ReactiveAI 3.0 Obstacle Recognition: Triple structured light, an RGB camera, and VertiBeam™ lateral sensing spot cords, toys, and furniture legs, steering around them instead of pushing through.
• Hot Water Mop Care at the Dock: Mop washing runs from 122 F up to 176 F with automatic detergent dosing, followed by heated air drying so pads do not sour between runs.
• AdaptiLift Chassis: Lifts to cross thresholds up to 1.57 inches, keeping multi-room and split-level homes on one cleaning schedule.

This configuration is built for households that mop daily and want zero water chores: big kitchens, tiled entryways, homes with kids or pets, and anyone who already has a laundry room, utility closet, or under-sink spot with a water line and drain nearby. The slim RetractSense body handles low furniture, the anti-tangle brushes shrug off pet hair, and the plumbed dock means the only recurring task left is swapping a dust bag every few weeks.

Within the Roborock lineup, it upgrades the plumbed S8 MaxV Ultra with Refill & Drainage System with more suction and the retractable-LDS slim design; the standard Saros 10 offers the same cleaning with tank-based water management, and the Saros 10R takes a solid-state navigation approach at the same flagship tier.

1. Unbox and remove protectors: Remove the packaging foam and protective strips from the robot and dock, and confirm the disposable dust bag is seated.
2. Place the dock near plumbing: Set the dock on hard, level flooring against a wall near an outlet, within reach of a household water supply line and a drain - a laundry room, bathroom, or under-sink location works well.
3. Connect water and drain lines: Hook the refill line to the water supply and route the drainage line to the drain per the manual, then check both connections for leaks before first use.
4. Charge the robot: Dock the Saros 10 and let the 6,400 mAh battery charge; a full fast charge takes about 2.5 hours.
5. Pair in the Roborock app: Add the robot over Bluetooth, connect it to 2.4 GHz Wi-Fi, and run the first mapping cycle so it builds and names your floor plan.
6. Automate it: Load detergent, then set schedules, no-go zones, and SmartPlan™ 2.0 room settings - water refilling and draining now run on their own.