Roborock Saros 10 Robot Vacuum with Dual Anti-tangle System (Upgraded from S8 MaxV Ultra)

The Saros 10 is Roborock's flagship-class robot vacuum and mop, the direct successor to the S8 MaxV Ultra. It pairs 22,000 Pa HyperForce® suction with the RetractSense™ Navigation System: the LDS turret physically retracts into the body, dropping the robot to an ultra-slim 3.14 inches (7.98 cm) so it cleans under sofas, beds, and cabinets that stop taller robots.

The Dual Anti-tangle System combines the DuoDivide™ main brush with the FlexiArm™ Riser side brush, and Roborock rates it at a 0 percent hair tangle rate with a 100 percent hair removal rate on carpet. For mopping, the VibraRise® 4.0 system scrubs with two sonic vibration zones at 4,000 cycles per minute each and up to 8N of downward pressure, while ReactiveAI 3.0 obstacle recognition reads the room through front triple structured light, an RGB camera, and VertiBeam™ lateral structured light.

This configuration includes the RockDock® Ultra 2.0 with self-contained water tanks - no plumbing required - handling dust emptying, 176 F hot water mop washing, heated drying, detergent dosing, and 2.5-hour fast charging. If you would rather plumb the dock into your water lines, the same robot is sold as the Saros 10 with Refill & Drainage System.

• 22,000 Pa HyperForce Suction: Roborock's strongest suction class in the Saros line pulls embedded grit out of carpet pile and along baseboard edges, backed by a 6,400 mAh battery and 2.5-hour fast charging.
• Dual Anti-tangle System: The DuoDivide™ main brush splits and channels hair to the suction inlet instead of wrapping it, and the FlexiArm™ Riser side brush uses an asymmetrical spiral arc - rated 0 percent hair tangle rate and 100 percent hair removal rate on carpet.
• RetractSense Navigation: The LDS turret retracts flush into the chassis, giving a 3.14-inch (7.98 cm) profile for under-furniture cleaning; a wide-angle vision module, upward range finder, and top contact sensor keep it from getting wedged.
• ReactiveAI 3.0 Obstacle Recognition: Front triple structured light, an RGB camera, and VertiBeam™ lateral structured light detect cords, shoes, pet bowls, and low obstacles, then route around them.
• VibraRise 4.0 Mopping: Two sonic vibration zones scrub at 4,000 cycles per minute with up to 8N of pressure and water heated up to 158 F; the mop detaches automatically in vacuum-only modes so carpet never sees a damp pad.
• AdaptiLift Chassis: The chassis lifts to cross thresholds up to 1.57 inches (a 1.18-inch step plus a 0.39-inch track), so split-level rooms and door tracks do not strand it.
• RockDock Ultra 2.0: Auto dust emptying, dynamic 122 F to 176 F hot water mop washing that removes 99.99 percent of tested bacteria, 140 F heated drying, tank refilling, and automatic detergent dispensing - all from self-contained tanks under a tempered glass lid.
• Quiet, Hands-Off Operation: 52 dB(A) in quiet mopping mode, SmartPlan™ 2.0 picks settings by room and floor type, and the built-in "Hello Rocky" voice assistant works even offline.

The Saros 10 suits large homes with mixed flooring - hardwood, tile, and carpet in the same run - and households with shedding pets or long-haired family members, where the anti-tangle brushes and camera-based obstacle recognition earn their keep daily. The retractable LDS makes it the pick for furniture-heavy rooms with low sofas and beds, and the AdaptiLift chassis handles split levels and thick transition strips that stop ordinary robots. Because the dock uses its own tanks, it works in any room with a wall outlet.

Within the Roborock lineup, this model replaces the S8 MaxV Ultra with stronger suction, the slimmer retractable-LDS design, and the newer dock; its sibling the Saros 10R swaps the retractable LDS for Roborock's StarSight solid-state navigation, and the Saros 10 with Refill & Drainage System is the same robot with a plumbed dock for fully hands-free water management.

1. Unbox and remove protectors: Take off the packaging foam and protective strips from the robot, bumper, and dock, and confirm the disposable dust bag is seated in the dock.
2. Place the dock: Set the RockDock® Ultra 2.0 on hard, level flooring against a wall near an outlet, leaving open floor in front and a little side clearance so the robot can dock straight.
3. Charge the robot: Dock the Saros 10 and let the 6,400 mAh battery charge; a full fast charge takes about 2.5 hours.
4. Pair in the Roborock app: Download the Roborock app, add the robot over Bluetooth, and connect it to your 2.4 GHz Wi-Fi network.
5. Run the first mapping cycle: Start a quick mapping run so the robot builds a floor plan, then name rooms and check the map in the app.
6. Dial in your routine: Fill the clean water tank and detergent, set schedules, no-go zones, and invisible walls, and let SmartPlan™ 2.0 choose modes per room.