Roborock Qrevo CurvX Robot Vacuum with Multifunctional Dock 3.0 Thermo+

The Roborock Qrevo CurvX packs 22,000 Pa of HyperForce suction into an ultra-slim 3.14 inch body, so it cleans under the sofas, beds, and media consoles that taller robots have to skip. Its AdaptiLift chassis raises the whole body - or individual sections of it - to climb thresholds up to 1.57 inches (4 cm), including double-layer transitions, while the Dual Anti-Tangle System keeps long hair and pet hair from wrapping the DuoDivide main brush or the FlexiArm arc side brush.

For mopping, dual spinning mops press down with 12 N of force, and FlexiArm extension reaches 0 mm from edges and corners. When the robot crosses carpet, the mops lift up to 17 mm. Back at the Multifunctional Dock 3.0 Thermo+, the mops get an 80 C (176 F) hot-water wash and 45 C (113 F) warm-air dry, and the dust bin auto-empties for up to 7 weeks at a time.

In the Roborock lineup, the CurvX is the slim, threshold-climbing all-rounder of the Qrevo family - a fit for homes with low-clearance furniture, raised doorways between rooms, and a mix of hard floors and carpet.

• 22,000 Pa HyperForce Suction: Enough draw to pull grit out of carpet pile and debris from grout lines, with automatic boosting where floors need it.
• 3.14 Inch Ultra-Slim Body: At about 80 mm tall with a retractable LiDAR module, the CurvX cleans under sofas, beds, and consoles that block standard-height robots.
• AdaptiLift Chassis: Lifts the entire chassis or individual sections to climb thresholds up to 1.57 in (4 cm) - including double-layer transitions between rooms - so multi-room homes get cleaned in one run.
• Dual Anti-Tangle System: The DuoDivide main brush splits and channels hair into the bin with a 0 percent tangling and 100 percent hair removal rate, and the FlexiArm arc side brush stays tangle-free too.
• FlexiArm Edge Mopping: The side brush and mop extend outward to reach 0 mm from walls and corners, with 12 N of mop pressure and a 17 mm lift over carpet.
• Multifunctional Dock 3.0 Thermo+: Washes mops with 80 C (176 F) hot water at a 99.99 percent bacteria removal rate, dries them with 45 C warm air, and auto-empties the dust bin for up to 7 weeks.
• Reactive AI Obstacle Recognition: RGB camera and structured light recognize 108 object types in daylight or dark, and the app adds pet snaps and video calls.
• 6,400 mAh Battery: A large battery for whole-home runs, managed automatically with recharge-and-resume.

The CurvX is built for homes where geometry is the challenge: low-slung furniture the robot must slip under, raised or double-layer thresholds between rooms, and a mix of carpet and hard flooring. Pet households get real benefits from the zero-tangle brush system, pet recognition, and the hot-water mop wash that keeps the mop pads from souring. The 53 dB mopping mode is quiet enough to run while the house is occupied.

Within the Qrevo family, pick the CurvX for slim clearance and threshold climbing; if roller-mop deep cleaning on hard floors is the priority, step to the Roborock Qrevo Curv 2 Flow, or compare the curved-design Roborock Qrevo Curv S5X with Multifunctional Dock 3.0.

1. Unbox and remove protectors: Remove all protective films and foam from the robot, dock, and mop assembly, and confirm the disposable dust bag is pre-installed in the dock.
2. Place the dock: Set the Multifunctional Dock 3.0 Thermo+ on a hard, level surface against a wall near an outlet, with open clearance on both sides and in front per the quick start guide.
3. Attach mops and fill water: Mount the mop cloths on their mounts, fill the clean water tank, and dock the robot.
4. Charge: Let the 6,400 mAh battery charge fully before the first cleaning run.
5. Pair in the Roborock app: Download the Roborock app and follow the pairing prompts to connect the robot to your home Wi-Fi.
6. Run the first mapping cycle: Start quick mapping, review room divisions, then set schedules, no-go zones, and no-mop zones - and let SmartPlan tailor routines by room and floor type.